Cant burn lua code using ESplorer Home › Forums › Modules › ESP8266 › Cant burn lua code using ESplorer Tagged: Firmware This topic contains 2 replies, has 3 voices, and was last updated by mel 2 years, 3 months ago. Viewing 3 posts - 1 through 3 (of 3 total) Author Posts May 2, 2015 at 1:30 pm #477 tarunParticipant I’m getting the following error when i tried to burn the lua code. “Can’t autodetect firmware, because proper answer not received.” I tried flashing nodemcu_float_0.9.6-dev_20150406.bin from https://github.com/nodemcu/nodemcu-firmware/releases. but getting the same error… please help me out…. May 13, 2015 at 12:04 am #481 nielsswParticipant Are you following the NodeLua tutorial? http://nodelua.org/doc/tutorial/make-your-first-node/ What command are you using, and which firmware? I’m not sure you can use esptool.py to upload nodemcu firmware. For that you should use https://github.com/nodemcu/nodemcu-flasher October 19, 2016 at 4:18 pm #519 melParticipant Hi Is it possible to use https://github.com/nodemcu/nodemcu-flasher to burn nodelua firmware? Author Posts Viewing 3 posts - 1 through 3 (of 3 total) You must be logged in to reply to this topic.